Toyota RAV4 Service Manual: Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove generator assembly
- Remove the generator assembly from the vehicle (see page ch-9).
- Remove crankshaft position sensor
- Disconnect the sensor connector.
- Remove the connector clamp.
- Remove the wire harness from the wire harness clamp bracket.
- Remove the wire harness clamp.
- Remove the bolt and sensor.
Crankshaft position sensor
Components
...
Inspection
Inspect crankshaft position sensor
Measure the resistance of the sensor.
Standard resistance
Notice:
Cold and hot mean the temperature of the coils
themselves. Cold is from -10 to ...
Other materials:
Lost communication with driver side - side airbag sensor assembly
Description
The side airbag sensor lh consists of part including the diagnostic circuit
and the lateral deceleration
sensor.
When the center airbag sensor receives signals from the lateral deceleration
sensor, it determines
whether or not the srs should be activated.
Dtc b1622/81 is ...
Inspection
Inspect starter assembly
Notice:
These tests must be performed within 3 to 5 seconds
to avoid burning out the coil.
Perform the pull-in test.
Disconnect the lead wire from terminal c.
Connect the battery to the magnetic switch as
shown in the illustration. Check that the clutch ...
Slip indicator light remains on
Description
The slip indicator blinks during vsc and/or trc operation.
When the system fails, the slip indicator comes on to warn the driver.
For 2wd: with auto lsd switch on, when the hydraulic brake booster is at a high
temperature, the slip
indicator illuminates.
Wiring diagram
In ...
