Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal

  1. Drain engine coolant (see page co-6)

  2. Disconnect cable from negative battery terminal

Caution:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Remove air cleaner cap (see page es-411)

  2. Remove air cleaner case (see page es-429)

  3. Remove engine coolant temperature sensor

Toyota RAV4. Removal


  1. Disconnect the sensor connector.
  2. Using sst, remove the sensor and gasket.

Sst 09817-33190

Engine coolant temperature sensor
Components ...

Inspection
Inspect engine coolant temperature sensor Measure the resistance of the sensor. Standard resistance Notice: If checking the sensor in water, be careful not to allow water to contac ...

Other materials:

Opening/closing the back door (vehicles with power back door)
â–  Using the wireless remote control Press and hold the switch. The power back door automatically opens/closes. Pressing the switch while the power back door is opening/closing stops the operation. When the switch is pressed and held again during the halted operation, the back door will perform t ...

Cleaning and protecting the vehicle exterior
Perform the following to protect the vehicle and maintain it in prime condition: Cleaning instructions Working from top to bottom, liberally apply water to the vehicle body, wheel wells and underside of the vehicle to remove any dirt and dust. Wash the vehicle body using a sponge or soft clo ...

Air conditioning filter
The air conditioning filter must be changed regularly to maintain air conditioning efficiency. Removal method 1. Turn the engine switch to OFF. 2. Open the glove box and slide off the damper. 3. Push in each side of the glove box to disconnect the claws, and then slowly and fully open the glove bo ...

© 2011-2026 Copyright www.trav4.net