Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal
- Drain engine coolant (see page co-6)
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove no. 1 Engine cover
- Remove the 2 nuts and engine cover.
- Remove air cleaner cap
- Disconnect the mass air flow meter connector.
- Disconnect the purge vsv connector.
- Disconnect the 4 wire harness clamps.
- Disconnect the no. 2 Ventilation hose from the air cleaner hose.
- Disconnect the purge line hose from the clamp.
- Lock the no. 1 Air cleaner hose clamp, and then disconnect the no. 1 Air cleaner hose from the throttle body.
- Unfasten the 2 hook clamps, and then remove the air cleaner cap.
- Remove the air cleaner filter element from the air cleaner case.
- Remove throttle body
- Disconnect the purge line hose from the throttle body.
- Disconnect the water by-pass hose from the throttle body.
- Disconnect the no. 2 Water by-pass hose from the throttle body.
- Disconnect the no. 1 Throttle body hose from the throttle body
- Disconnect the throttle position sensor and control motor connector.
- Disconnect the wire harness clamp.
- Disconnect the fuel tube from the clamp.
- Remove the 4 bolts, and then remove the fuel pipe support and throttle body.
- Remove the gasket from the intake manifold
On-vehicle inspection
Check throttle body
Check the throttle control motor operating sounds.
Turn the ignition switch on.
When pressing the accelerator pedal, check
the operating sound of the running mot ...
Inspection
Inspect throttle body
Measure the resistance of the throttle control motor.
Standard resistance
If the result is not as specified, replace the throttle
body. ...
Other materials:
Installation
Install no. 2 Chain sub-assembly
Set the crankshaft key in the left horizontal position.
Turn the cutout of the drive shaft so that it faces
upward.
Align the yellow mark links with the timing marks of
each gear as shown in the illustration.
Install the sprockets onto ...
Side doors
Unlocking and locking the doors
The vehicle can be locked and unlocked using the key, entry function,
wireless remote control or door lock switch.
Entry function (if equipped)
Wireless remote control
Key
Vehicles without a smart key system
Locks all the doors
Unlocks all the doors
Tur ...
Emission control system
Parts location
System diagram
On-vehicle inspection
Check fuel cut rpm
Increase the engine speed to at least 3,500 rpm.
Use a sound scope to check for injector operating
noise.
Check that the operating sounds stop momentarily
and then resume when the t ...
