Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove no. 1 Engine under cover
- Remove front fender apron rh
- Remove radiator support opening cover
- Drain engine coolant (see page co-6)
- Remove front suspension member reinforcement rh (see page em-6)
- Remove fan and generator v belt (see page em-6)
- Remove generator assembly (see page ch-9)
- Remove water pump pulley
- Using sst, remove the 4 bolts and water pump pulley.
Sst 09960-10010 (09962-01000, 09963-00700)
- Remove water pump assembly
- Remove the clamp of the crankshaft position sensor from the water pump.
- Disconnect the wire of the crankshaft position sensor from the clamp bracket.
- Remove the 4 bolts, 2 nuts and clamp bracket.
- Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
Notice:
Be careful not to damage the contact surfaces of the water pump and cylinder block.
Water pump
...
Inspection
Inspect water pump assembly
Visually check the drain hole for coolant leakage.
If leakage is found, replace the water pump
assembly.
Turn the pulley, and then check that the water ...
Other materials:
Diaphragm oil seal
Components
Removal
Drain differential oil
Using a 10 mm socket hexagon wrench, remove the
rear differential drain plug and gasket, and drain the
oil.
Install a new gasket to the rear differential drain
plug.
Using a 10 mm socket hexagon wrench, install the
rear differe ...
Registering a bluetooth®
phone for the first time
To use the hands-free system, it is necessary to register a
bluetooth® phone with the system.
Once the phone has been registered, it is possible to use the
hands-free system.
For details about registering a bluetooth® device
Turn the bluetooth® connection setting of your cellular phon ...
Bluetooth® phone
settings
You can adjust the hands-free system to your desired settings.
“Phone/message settings” screen
To display the screen shown below, press the “setup” button, and
select “phone” on the “setup” screen.
Set the phone connection
Setting the sound
Contact/call history settings
...
