Toyota RAV4 Service Manual: Removal and installation of fuel control parts
- Place for removing and installing fuel system parts
- Work in a location with good air ventilation that does not have welders, grinders, drills, electric motors, stoves, or any other ignition sources.
- Never work in a pit or near a pit as vaporized fuel will collect in those places.
- Removing and installing fuel system parts
- Prepare a fire extinguisher before starting the operation.
- To prevent static electricity, install a ground wire to the fuel changer, vehicle and fuel tank, and do not spray the surrounding area with water. Be careful when performing work in this area, as the work surface will become slippery. Do not clean up gasoline spills with water, as this may cause the gasoline to spread, and possibly create a fire hazard.
- Avoid using electric motors, working lights and other electric equipment that can cause sparks or high temperatures.
- Avoid using iron hammers as they may create sparks.
- Dispose of fuel-contaminated cloth separately using a fire resistant container.
Electronic control
Removal and installation of battery
terminal
Notice:
Certain systems need to be initialized after
disconnecting and reconnecting the cable from
the negative (-) battery terminal.
Be ...
Removal and installation of engine intake parts
If any metal particles enter inlet system parts, they
may damage the engine.
When removing and installing inlet system parts,
cover the openings of the removed parts and engine
openings ...
Other materials:
Trailer tongue weight
A recommended tongue weight varies in accordance with the types
of trailers or towing as described below.
To ensure the recommended values shown below, the trailer must
be loaded by referring to the following instructions.
Tongue weight
The gross trailer weight should be distributed so ...
When servicing active torque control 4wd vehicles
The active torque control 4wd rav4 is equipped
with the 4 wheel drive control system.
If incorrect preparations or test procedures are
used, the test will not only be unsuccessful, but may
be dangerous as well.
Caution:
Never accelerate or decelerate the vehicle
suddenly.
Obs ...
Horn relay
On-vehicle inspection
Remove engine room no. 1 Relay block cover
Inspect integration relay (unit a: horn relay)
Using a screwdriver, detach the 2 claws and
disconnect the integration relay from the engine
room junction block.
Hint:
Tape the screwdriver tip before use.
Mea ...
