Toyota RAV4 Service Manual: Replacement
- Replace timing chain cover oil seal
- Using a screwdriver and hammer, tap out the oil seal.
- Place the oil seal retainer on wooden blocks.
- Apply multi-purpose grease to the lip of a new oil seal.
Notice:
Keep the lip free of foreign objects.
- Using sst and a hammer, tap in a new oil seal until its surface is flush with the timing gear case edge.
Sst 09223-22010
Notice:
Do not tap the oil seal at an angle.
Inspection
Inspect no. 1 Chain tensioner
Check that the plunger moves smoothly when the
ratchet pawl is raised with your finger.
Release the ratchet pawl, then check that the
plunger is locked ...
Installation
Install no. 2 Chain sub-assembly
Set the crankshaft key in the left horizontal position.
Turn the cutout of the drive shaft so that it faces
upward.
Align the yellow mark li ...
Other materials:
Center power outlet socket (for ac power supply)
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove console rear end panel (see page ip-
19)
...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
Front power seat lumbar switch
Inspection
Inspect front power seat lumbar switch lh
Measure the resistance between the terminals when
the switch is operated.
Standard resistance
If the result is not as specified, replace the switch. ...
