Toyota RAV4 Service Manual: Replacement
- Replace generator drive end frame bearing
- Remove the 4 screws and bearing retainer.
- Using sst and a hammer, tap out the bearing.
Sst 09950-60010 (09951-00250), 09950-70010 (09951-07100)
- Using sst and a press, press in a new bearing.
Sst 09950-60010 (09951-00250), 09950-70010 (09951-07100)
- Install the bearing retainer with the 4 screws.
Torque: 2.3 N*m (23 kgf*cm, 20 in.*Lbf)
Inspection
Inspect generator brush holder assembly
Using a vernier caliper, measure the brush length.
Standard length:
9.5 To 11.5 Mm (0.374 To 0.453 In.)
Minimum length:
4.5 Mm (0.177 In.)
If th ...
Reassembly
Install generator rotor assembly
Install the washer onto the generator rectifier end
frame.
Install the generator rotor onto the generator
rectifier end frame.
Usi ...
Other materials:
Adjusting the settings
To adjust the fan speed, turn the fan speed control dial clockwise
(increase) or counterclockwise (decrease).
Turning the dial to “0” turns off the fan.
To adjust the temperature setting, turn the temperature control dial
clockwise (warm) or counterclockwise (cool).
If is ...
Antenna coil open / short
Description
The transponder key coil receives key code signals from the transponder chip
in the key grip. The coil
built into the transponder key amplifier amplifies the key code signals and
outputs the signal to the
transponder key ecu.
Wiring diagram
Inspection procedure
R ...
Compressor circuit
Description
When the a/c switch is turned on, the magnetic clutch on signal is sent from
the air conditioning
amplifier. Then the mg clt relay turns on to operate the magnetic clutch.
Wiring diagram
Inspection procedure
Perform active test by intelligent tester (a/c mag clutch)
C ...
