Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Reporting safety defects for u.S. Owners

Toyota RAV4 (XA40) 2013-2018 Owners Manual / For owners / Reporting safety defects for u.S. Owners

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the national highway traffic safety administration (nhtsa) in addition to notifying toyota motor sales, u.S.A., Inc.

(Toll-free: 1-800-331-4331).

If nhtsa receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign. However, nhtsa cannot become involved in individual problems between you, your dealer, or toyota motor sales, u.S.A., Inc.

To contact nhtsa, you may call the vehicle safety hotline toll-free at 1-888-327-4236 (tty: 1-800-424-9153); go to http://www.Safercar.Gov ; or write to: administrator, nhtsa, 1200 new jersey ave, s.E., Washington, dc 20590. You can also obtain other information about motor vehicle safety from http://www.Safercar.Gov.

For owners
...

Seat belt instructions for canadian owners (in french)
The following is a french explanation of seat belt instructions extracted from the seat belt section in this manual. See the seat belt section for more detailed seat belt instructions in english. ...

Other materials:

Brake pedal load sensing switch
On-vehicle inspection Inspect brake pedal load sensing switch Hint: Do not remove the brake pedal load sensing switch from the brake pedal support. When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support. Disconnect the brake pedal l ...

Outside vehicle
General maintenance Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tools are not requ ...

Data list / active test
Read data list Hint: Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time. Connect the intelligent tester (with can vim) to the dlc3 ...

В© 2011-2026 Copyright www.trav4.net