Toyota RAV4 Service Manual: Road test
- Inspect set switch
- Push the main switch on.
- Drive at a desired speed (40 km/h (25 mph) or higher).
- Inspect "+" switch
- Push the main switch button on.
- Drive at a desired speed (40 km/h (25 mph) or higher).
- Press the control switch to -/set.
- Check that the vehicle speed increases while the control switch is pressed to +/res, and that the vehicle cruises at the set speed when the switch is released.
- Momentarily press the control switch to +/res and then immediately release it. Check that the vehicle speed increases by about 1.6 Km/h (1 mph) (tap-up function).
- Inspect "-" switch
- Push the main switch button on.
- Drive at a desired speed (40 km/h (25 mph) or higher).
- Press the control switch to -/set.
- Check that the vehicle speed decreases while the control switch is pressed to -/set, and the vehicle cruises at the set speed when the switch is released.
- Momentarily press the control switch to -/set, and then immediately release it. Check that the vehicle speed decreases by about 1.6 Km/h (1 mph) (tapdown function).
- Inspect cancel switch
- Push the main switch button on.
- Drive at a desired speed (40 km/h (25 mph) or higher).
- Press the control switch to -/set.
- When operating one of the following, check that the cruise control system is canceled.
- Depressing the brake pedal
- Pushing the cruise control main switch off
- Pulling the cruise control switch to cancel
- Moving the shift lever to any position except d or 3
- Inspect res (resume) switch
- Push the main switch button on.
- Drive at a desired speed (40 km/h (25 mph) or higher).
- Press the control switch to -/set.
- When operating one of the following, check that the cruise control system is canceled.
- Depressing the brake pedal
- Pulling the cruise control switch to cancel
- Moving the shift lever to any position except d or 3
- After the control switch is pressed to +/res at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed before the cancellation.
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the cruise control
system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
11 ...
Registration
Perform vehicle stability control system recognition in ecm
Notice:
If the vehicle has both cruise control and vsc, when
replacing ecm, perform vsc recognition as follows:
Turn the ignitio ...
Other materials:
Problem symptoms table (2005/11-2006/01)
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column
of the table. Check each symptom by checking the suspected
areas in the order they are listed. Replace p ...
Removal (2005/11-2006/01)
Remove front wheel
Drain automatic transaxle fluid
Drain the automatic transaxle fluid for u140f (see
page ax-147).
Drain the automatic transaxle fluid for u241e (see
page ax-146).
Remove front axle hub nut (see page ah-6)
Disconnect front speed sensor lh
Disconnect th ...
Window lock switch
Press the switch to lock the passenger
window switches.
Use this switch to prevent children
from accidentally opening or closing
a passenger window.
The power windows can be operated when
Vehicles without a smart key system
The engine switch is in the “on” position.
Vehicles ...
