Toyota RAV4 (XA40) 2013-2018 Service Manual: Seat belt
- Seat belt warning system
- System description
- How to proceed with troubleshooting
- Operation check
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Data list / active test
- On-vehicle inspection
- Front seat inner belt assembly
- Front seat outer belt assembly
- Rear seat inner belt assembly
- Rear seat outer belt assembly
- Rear center seat outer belt assembly
- Child restraint seat tether anchor
Front seat cushion heater
Inspection
Inspect front seat cushion heater
assembly lh
Measure the resistance of the seat cushion heater.
Standard resistance
If the result is not as specified, replace the seat ...
Seat belt warning system
Parts location
System diagram
...
Other materials:
Check mode procedure
Panel diagnosis (indicator check)
Turn the ignition switch to lock.
Turn the ignition switch on while simultaneously
pressing the a/c control auto switch and the rec/
frs switch.
Check that all indicators and the display area are
turned on and off 4 times in succession at 1 second ...
Exhaust pipe
Components
Removal
Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove heated oxygen sensor (for bank 1
sensor 2) (s ...
Adjusting the open position of the back door (vehicles with a power back door)
The open position of the power back door can be adjusted.
Open the back door, and adjust it to the desired position.
Press and hold the power back door switch on the back door until
the buzzer sounds 4 times.
Luggage compartment light
The luggage compartment light turns on when the back ...
