Toyota RAV4 Service Manual: Seat belt warning system
Parts location
System diagram
- System description
- How to proceed with troubleshooting
- Operation check
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Data list / active test
- On-vehicle inspection
Seat belt
...
System description
Driver seat belt warning light
When the driver seat belt is not fastened with the
ignition switch on, the driver seat belt warning light
on the combination meter comes on to inform the
...
Other materials:
Eps warning light circuit
Description
If the power steering ecu detects a malfunction, the p/s warning light comes
on. At this time, the power
steering ecu stores a dtc in its memory.
Wiring diagram
Inspection procedure
Check for dtc
Using the intelligent tester (with can vim), check for
dtcs and confir ...
Installation
Hint:
When installing the spoiler, heat the vehicle body and
spoiler using a heat light.
Standard heating temperature
Notice:
Do not heat the body and spoiler excessively.
Install center stop light
Install the center stop light with the 2 screws.
Install rear spoiler
...
Transmission control cable assembly
Replacement
Remove rear console box sub-assembly
Remove the console box (see page ip-20).
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pre ...
