Description
When the sliding roof drive gear (sliding roof ecu) detects the motor's malfunction, and the sliding roof operation is stopped, dtc b2341 is output. When the sliding roof drive gear (sliding roof ecu) detects the gear's malfunction, and the sliding roof operation is stopped, dtc b2344 is output.
Wiring diagram
Inspection procedure
Ok: auto operation operates normally with slide open and tilt up switch.
End
Ok: sliding roof drive gear can be initialized.
Ok: auto operation operates normally with slide open and tilt up switch.
End
Standard resistance
Standard resistance
Replace sliding roof drive gear sub-assembly (sliding roof ecu)
Inspection
Inspect cylinder head for warpage
Using a precision straightedge and feeler gauge,
measure the warpage of the contact surfaces of the
cylinder block and manifolds.
Maximum warpage:
0.08 Mm (0.0032 In.)
If the warpage is greater than the maximum, replace
the cylinder head sub-a ...
Diagnosis system
Bus check
Select "bus check" from the "obd / mobd
menu" screen.
Hint:
The ecus and sensors that are properly connected
to the can communication system can be displayed
using the intelligent tester via can vim.
Press "enter" on the intelligen ...
Rear airbag sensor
Components
On-vehicle inspection
Check rear airbag sensor (vehicle not
involved in collision)
Perform a diagnostic system check (see page rs-
49).
Check rear airbag sensor (vehicle
involved in collision and airbag has not
deployed)
Perform a diagnostic system check ...