Toyota RAV4 (XA40) 2013-2018 Owners Manual: Setup menu
You can adjust the audio system to your desired settings.
Display “setup” screen
Press the “setup” button to display the “setup” screen.
- Select to adjust the settings for operation sounds, screen animation, etc.
- Select to display the voice settings screen.
- Select to adjust the settings for contrast and brightness of the screen.
- Select to adjust the settings for registering, removing, connecting and disconnecting bluetooth® devices.
- Select to adjust the settings for contact, message settings, etc.
- Select to set audio settings.
- Select to turn the screen off.
- Select to set the vehicle customization
Basic audio operations
Basic audio operations and functions common to each mode are
explained in this section.
Operating the audio system
Press this knob to turn the
audio system on and off, and
turn it to adj ...
General settings
Settings are available for adjusting the operation sounds,
screen animation, etc. ...
Other materials:
Power steering ecu
Components
Removal
Disconnect cable from negative battery
terminal
Remove instrument panel sub-assembly
upper
Remove the instrument panel (see page ip-4).
Remove power steering ecu
Disconnect the 4 connectors.
Remove the 3 nuts and remove the power steering
e ...
Wheels
If a wheel is bent, cracked or
heavily corroded, it should
be replaced. Otherwise, the
tire may separate from the
wheel or cause a loss of
handling control.
Wheel selection
When replacing wheels, care
should be taken to ensure that
they are equivalent to those
removed in load capacity, diameter,
rim ...
Downhill assist control operation switch (test mode dtc)
Description
The downhill assist control switch is connected to the skid control ecu in
the abs and traction
actuator.
Dtc c1379/74 can be detected when the downhill assist control switch sends the
downhill assist control
switch signal or test mode ends. Dtc c1379/74 is output only in t ...
