Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Sfi system

Reassembly
Install piston Using a small screwdriver, install a new snap ring onto one end of the piston pin hole. Hint: Make sure that the end gap of the snap ring is not aligned with the pin ...

Precaution
Notice: Perform reset memory (at initialization) when replacing the automatic transmission assembly, engine assembly or ecm (see page ax-18). Perform registration (vin registration) when r ...

Other materials:

Brake pedal load sensing switch
Description The brake pedal load sensing switch is turned on when the brake pedal is depressed with force exceeding a predetermined level. The skid control ecu detects if the brake pedal is depressed or not via this circuit. Wiring diagram Inspection procedure Notice: When repla ...

For vehicles equipped with mobile communication systems
Install the antenna as far away from the ecu and sensors of the vehicle electronic systems as possible. Install an antenna feeder at least 20 cm (7.87 In.) Away from the ecu and sensors of the vehicle electronic systems. For details about ecu and sensor locations, refer to the sec ...

Check mode procedure
Hint: Intelligent tester only: compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode. Notice: All the stored dtcs and freeze frame data are erased if: The ecm is changed from normal mo ...

В© 2011-2026 Copyright www.trav4.net