System description
The ecm uses signals from the output shaft speed sensor and input speed sensor to detect the actual gear position (1st, 2nd, 3rd or o/d gear).
Then the ecm compares the actual gear with the shift schedule in the ecm memory to detect mechanical problems of the shift solenoid valves, valve body or automatic transaxle (clutch, brake, gear, etc.).
Monitor description
This dtc indicates a stuck off malfunction of the shift solenoid valve s4, stuck on malfunction of the shift solenoid valve sl2, or brake control valve malfunction. The ecm commands gear shifts by turning the shift solenoid valves on/off. When the gear position commanded by the ecm and the actual gear position are not the same, the ecm illuminates the mil and stores the dtc.
Monitor strategy
Typical enabling conditions
Typical malfunction thresholds
Either of the following conditions is met: off malfunction or on malfunction
2 Detections are necessary per driving cycle: 1st detection: temporary flag on
2Nd detection: pending fault code on
Inspection procedure
Hint:
Performing the intelligent tester's active test allows relay, vsv, actuator and other items to be operated without removing any parts. Performing the active test early in troubleshooting is one way to save time.
The data list can be displayed during the active test.
Hint:
While driving, the shift position can be forcibly changed with the tester.
Comparing the shift position commanded by the active test with the actual shift position enables you to confirm the problem (see page ax-31).
Hint:
Result
Hint:
If any other codes besides p0766 are output, perform troubleshooting for those dtcs first.
Standard resistance: 11 to 15 at 20°c (68°f)
Ok: valve moves and makes operating noise.
Ok: there are no foreign objects on each valve.
Ok: the torque converter clutch operates normally.
Repair or replace automatic transaxle assembly
Master cylinder pressure sensor malfunction
Description
The master cylinder pressure sensor is connected to the skid control ecu in
the abs and traction
actuator.
Dtc c1281/81 can be detected when the master cylinder pressure sensor sends a
master cylinder
pressure signal or test mode ends. Dtc c1281/81 is output only in test mo ...
Downhill assist control switch
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove downhill assist control switch
Detach t ...
System voltage
Description
The battery supplies electricity to the ecm even when the ignition switch is
in the off position. This
power allows the ecm to store data such as dtc history, freeze frame data and
fuel trim values. If the
battery voltage falls below a minimum level, the memory is cleared and ...