Toyota RAV4 Service Manual: Skid control buzzer circuit
Description
The skid control buzzer sounds while the vsc is activated.
Wiring diagram
Inspection procedure
Notice:
When replacing the abs and traction actuator, perform the zero point calibration (see page bc- 24).
- Check can communication system
- Check if the can communication dtc is output (see page ca-34).
Result 
- Perform active test by intelligent tester (skid control buzzer)
- Select the active test, generate a control command, and then check that the skid control buzzer operate.
Ok: the skid control buzzer can be heard.
- Inspect combination meter
- Inspect the combination meter (see page me-15).
Replace abs and traction actuator assembly
Auto lsd indicator light does not come on
Description
Refer to the description of "auto lsd indicator light remains on" (see page
bc-164).
Wiring diagram
Refer to the auto lsd indicator light circuit (see page bc-165).
Inspect ...
Tc and cg terminal circuit
Description
Connecting terminals tc and cg of the dlc3 causes the skid control ecu to
display 2-digit dtcs by
flashing the abs warning light.
Wiring diagram
Inspection procedure
Check dl ...
Other materials:
Audio system
Operations such as listening to audio, using the hands-free
phone, confirming vehicle information and changing audio system
settings are started by using the following buttons.
Audio system operation buttons
“Audio” button
Display the “select audio source” screen or audio top s ...
Downhill assist control indicator light remains on
Description
When the downhill assist control switch is pushed on, the downhill assist
control function is available and
the downhill assist control indicator light illuminates.
Hint:
Even if the downhill assist control switch is pressed, the downhill assist
control indicator light will blink ...
Starter relay circuit high
Description
While the engine is being cranked, the positive battery voltage is applied to
terminal sta of the ecm. If
the ecm detects the starter control (sta) signal while the vehicle is being
driven, it determines that there
is a malfunction in the sta circuit. The ecm then illuminates ...
