Description
During sleep mode, the occupant classification ecu reads the condition of each sensor while the ignition switch is off.
In this mode, if the occupant classification ecu detects an internal malfunction, dtc b1796 is output.
Inspection procedure
Hint
First clear dtcs stored in the occupant classification ecu and then in the center airbag sensor assembly.
Ok: dtc b1796 is not output.
Hint:
Dtcs other than dtc b1796 may be output at this time, but they are not related to this check.
Hint:
Perform the inspection using parts from a normal vehicle if possible.
Ok: completed is displayed.
Standard value: 27 to 33 kg (59.52 To 72.75 Lb)
End
Rear combination light assembly
Components
Removal
Hint:
Use the same procedures for the rh and lh sides.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal t ...
Operation check
Inspect driver side seat belt warning light
Turn the ignition switch on.
When the driver seat belt is not fastened, check that
the driver seat belt warning light on the combination
meter blinks.
When the driver seat belt is fastened, check that the
driver seat belt warning light o ...
Removal (2006/01- )
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove roof headlining assembly
Remove the roof headlining (see page ir ...