Toyota RAV4 (XA40) 2013-2018 Service Manual: Sliding roof housing

Sliding roof control switch circuit

Description If either the sliding function or tilt function does not operate, there may be a malfunction in the sliding roof control switch circuit. Wiring diagram Inspection procedure P ...

Components (2005/11-2006/01)

Sliding roof ecu power source circuit Description If the sliding function and tilt function do not operate, there may be a malfunction in the sliding ro ...

Other materials:

Fuel pump control circuit
Description When the engine is cranked, the starter relay drive signal output from the star terminal of the ecm is input into the sta terminal of the ecm, and ne signal generated by the crankshaft position sensor is also input into the ne+ terminal. Thus, the ecm interprets that the engine is ...

Installation
Install engine coolant temperature sensor Install a new gasket onto the sensor. Using sst, install the sensor. Sst 09817-33190 torque: 19.6 N*m (200 kgf*cm, 14 ft.*Lbf) Connect the sensor connector. Install air cleaner case (see page es-431) Install air cleaner cap ( ...

Rear coil spring
Components Removal Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove rear wheel Remove skid control sensor wire (for 2wd) (see page bc-198) Remove rear speed sensor lh (for 4wd) (see page bc-205) Disconnect ...