Removal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Hint:
Tape the clip remover tip before use.
Inspection
Standard resistance
If the result is not as specified, replace the map light assembly.
Installation
Transmission wire
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove no. 1 Engine under cover
Drain automati ...
Front seatback heater
Inspection
Inspect front seatback heater assembly
lh
Measure the resistance of the seatback heater.
Standard resistance
If the result is not as specified, replace the seatback
heater assembly
Inspect front seatback heater assembly
rh
Hint:
Use the same procedures desc ...
Disassembly
Hint:
When removing the ornament plate and emblem, heat the
radiator grille, ornament plate and emblem using a heat light.
Standard heating temperature
Notice:
Do not heat the radiator grille, ornament plate and
emblem excessively.
Remove hood to radiator grille seal
Remove th ...