Toyota RAV4 Service Manual: Source voltage drop
Description
The srs is equipped with a voltage-increase circuit (dc-dc converter) in the center airbag sensor in case the source voltage drops.
When the source voltage drops, the voltage-increase circuit (dc-dc converter) functions to increase the voltage of the srs to a normal working level.
A malfunction in this circuit is displayed differently from other codes, in the fact that no dtcs are recorded. With a normal system code present, the source voltage drop is indicated when the srs warning light comes on.
A malfunction in this circuit is not recorded in the center airbag sensor .
The srs warning light automatically goes off when the source voltage returns to normal.
Wiring diagram
Inspection procedure
- Check wire harness (center airbag sensor assembly - battery)
- Turn the ignition switch off.
- Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
- Disconnect the e45 connector from the center airbag sensor .
- Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
- Measure the voltage of the wire harness side connectors.
Standard voltage 
- Check wire harness (center airbag sensor assembly - body ground)
- Measure the resistance of the wire harness side connectors.
Standard resistance 
- Check wire harness (center airbag sensor assembly - body ground)
- Measure the resistance of the wire harness side connectors.
Standard resistance 
- Check srs warning light
- Turn the ignition switch off.
- Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
- Connect the e45 center airbag sensor connector.
- Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
- Turn the ignition switch on, and wait for at least 6 seconds.
- Operate all components of the electrical system (defogger, wiper, headlight, heater, blower, etc.) And check that the srs warning light does not come on.
Ok: srs warning light does not come on.
End
Short in front passenger side pretensioner squib circuit
Description
The front passenger side front pretensioner squib circuit consists of the
center airbag sensor and the front
seat outer belt rh.
This circuit instructs the srs to deploy whe ...
Srs warning light remains on
Description
The srs warning light is located on the combination meter.
When the srs is normal, the srs warning light comes on for approximately 6
seconds after the ignition
switch is turned fro ...
Other materials:
Customer problem analysis
Hint:
In troubleshooting, confirm that the problem symptoms
have been accurately identified. Preconceptions should be
discarded in order to make an accurate judgment. To
clearly understand what the problem symptoms are, it is
extremely important to ask the customer about the
problem an ...
System description
General
This system has the following functions: manual slide
open and close; auto slide open and close; manual tilt up
and down; auto tilt up and down; jam protection; and key
off operation.
Function of main component
System operation
The sliding roof has the following ...
Rear occupant classification sensor lh collision detection
Description
Dtc b1787 is output when the occupant classification ecu receives a collision
detection signal sent by
the rear occupant classification sensor lh when an accident occurs.
Dtc b1787 is also output when the front seat assembly rh is subjected to a
strong impact, even if an
actua ...
