Components
Removal
Caution:
Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Notice:
When handling the airbag connector, do not damage the airbag wire harness.
Inspection
Installation
Caution:
Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
Notice:
Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.
Notice:
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.
Notice:
When handling the airbag connector, do not damage the airbag wire harness.
Notice:
do not use the airbag wire harness to turn the spiral cable.
Notice:
Do not use the airbag wire harness to turn the spiral cable.
Hint:
The spiral cable will rotate approximately 2.5 Turns to the left and right from the center.
Bluetooth® audio/phone
Bluetooth® audio
The bluetooth® audio system enables you to enjoy music played on
a portable digital audio player (portable player) from the vehicle
speakers via wireless communication.
This audio system supports bluetooth®, a wireless data system
capable of playing portable audio music wi ...
Mass air flow circuit range / performance problem
Description
Refer to dtc p0100 (see page es-86).
Monitor description
The maf meter is a sensor that measures the amount of air flowing through the
throttle valve. The ecm
uses this information to determine the fuel injection time and to provide an
appropriate air-fuel ratio. Inside
...
Diagnosis system
Description
The occupant classification ecu controls the functions of
the occupant classification system on the vehicle. Data
of the occupant classification system can be read in the
data link connector 3 (dlc3) of the vehicle. When the
system seems to be malfunctioning, use the intelligen ...