Description
The skid control ecu learns the steering sensor zero point every time the ignition switch is turned on and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ecu also stores the previous zero point.
If front wheel alignment or the steering wheel position is adjusted without disconnecting the negative battery terminal, or if the yaw rate and deceleration sensor zero point is not set after the adjustments have been completed, the skid control ecu detects the difference between the previously stored zero point and the newly learned zero point and outputs this dtc to indicate a poor adjustment.
Indication of the steering sensor zero point malfunction is canceled by turning the ignition switch off.
Inspection procedure
Notice:
When replacing the abs and traction actuator, perform zero point calibration (see page bc-24).
Hint:
Hint:
If the front wheel alignment and steering position are adjusted due to an incorrectly centered position of the steering wheel, set the yaw rate and deceleration sensor zero point again after the adjustments are completed.
Ok: the center position of the steering wheel is correctly set.
Result
Use simulation method to check
Selecting the driving mode
The following modes can be selected to suit driving conditions.
Eco drive mode
Use eco drive mode to help achieve low fuel consumption during
trips that involve frequent accelerating.
Press the “eco mode” button
to select eco drive mode.
The “eco mode” indicator
comes on.
Press t ...
Brake switch "b" circuit high
Description
The purpose of this circuit is to prevent the engine from stalling while
driving in the lock-up condition when
the brakes are suddenly applied.
When the brake pedal is depressed, this switch sends a signal to the ecm. Then
the ecm cancels the
operation of the lock-up clutch ...
Voice command system
The voice command system enables the hands-free system to
be operated using voice commands.
Using the voice command system
Press the talk switch.
To cancel the voice command system,
press and hold the talk switch.
After a beep sounds, say the desired command.
On the list screen, ...