Toyota RAV4 (XA40) 2013-2018 Service Manual: Supplemental restraint system
- Airbag system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
- Occupant classification system
- Precaution
- System description
- How to proceed with troubleshooting
- Initialization
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Dtc check / clear
- Data list / active test
- Diagnostic trouble code chart
- Steering pad
- Spiral cable
- Front passenger airbag assembly
- Curtain shield airbag assembly
- Front seat side airbag assembly
- Sruepsptrleaminetnstal restraint system center airbag sensor assembly
- Front airbag sensor
- Side airbag sensor
- Rear airbag sensor
- Seat position sensor
- Occupant classification ecu
Washer motor
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Airbag system
...
Other materials:
All doors cannot be locked / unlocked simultaneously
Description
The main body ecu receives switch signals from the door control switch on the
power window regulator
master switch, door control switch and driver side door key cylinder, and
activates the door lock motor on
each door accordingly.
Wiring diagram
Inspection procedure
Perf ...
Short in front driver side pretensioner squib circuit
Description
The driver side front pretensioner squib circuit consists of the center
airbag sensor and the front seat
outer belt lh.
This circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in the front prete ...
Power supply relay failure
Description
If the power steering ecu detects these dtcs, it shuts off the motor relay
circuit (built into the power
steering ecu) and stops power assist.
Inspection procedure
Reconfirm dtc
Check for dtc.
Ok:
dtc is not output.
Replace power steering ecu ...
