Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: System description

  1. Driver seat belt warning light

  1. When the driver seat belt is not fastened with the ignition switch on, the driver seat belt warning light on the combination meter comes on to inform the driver. The center airbag sensor detects the driver seat belt status and sends signals to the combination meter through the can bus line.
  1. Passenger seat belt warning light

  1. For automatic air conditioning system: when the passenger seat belt is not fastened with the ignition switch on and the passenger seat occupied, check that the passenger seat belt warning light on the heater control panel display blinks. The combination meter detects the passenger seat belt status and whether the passenger seat is occupied.
  2. For manual air conditioning system: when the passenger seat belt is not fastened with the ignition switch on and the passenger seat occupied, check that the passenger seat belt warning light on the clock panel blinks. The combination meter detects the passenger seat belt status and whether the passenger seat is occupied.
Seat belt warning system
Parts location System diagram ...

How to proceed with troubleshooting
Hint: Use these procedures to troubleshoot the seat belt warning system. *: Use the intelligent tester. Vehicle brought to workshop Inspect battery voltage Standard voltage: ...

Other materials:

General maintenance
Listed below are the general maintenance items that should be performed at the intervals specified in the “owner’s warranty information booklet� or “owner’s manual supplement/scheduled maintenance guide�. It is recommended that any problem you notice should be brought to the attentio ...

Installation
Install camshaft position sensor Notice: Make sure that the o-ring is not cracked or jammed when installing it. Apply a light coat of engine oil to the o-ring of the sensor. Install the sensor with the bolt. Torque: 9.0 N*m (90 kgf*cm, 80 in.*Lbf) Connect the sensor co ...

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the rh side. Remove front seat headrest assembly Remove front seat assembly Operate the power seat switch knob and move the seat to the foremost position. Using a screwdriver, d ...

© 2011-2026 Copyright www.trav4.net