Toyota RAV4 (XA40) 2013-2018 Service Manual: System description
- Power door lock system description
- The power door lock system locks / unlocks all doors with a one-touch operation.
- The door control switch of the power window regulator master switch or door control switch on passenger side sends lock / unlock request signals to the main body ecu. Then, the main body ecu sends these requests to the lock motors in each door to lock / unlock all the doors simultaneously.
- Operating the driver side door lock using a key sends lock / unlock request signals to the main body ecu.
- Components
- Functions
This system is controlled by the main body ecu. The main body ecu outputs signals to each door lock motor.
The door lock control system in the vehicle has the following functions:
Parts location
System diagram
...
How to proceed with troubleshooting
Hint:
Use the procedure to troubleshoot the power door lock
control system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltag ...
Other materials:
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove no. 1 Engine cover (see page es-410)
Remove camshaft timing oil cont ...
Registration
Hint:
The key has 2 codes: the key code (immobiliser code) and
the wireless code (recognition code). Both of these codes
need to be registered. For wireless code registration
procedures, refer to the following procedures (see page dl-
46). For key code registration procedures, refer to the
pro ...
Folding the mirrors
Push the mirror back in the direction
of the vehicle’s rear.
Mirror angle can be adjusted when
Vehicles without a smart key system
The engine switch is in the “acc” or “on” position.
Vehicles with a smart key system
The engine switch is in accessory or ignition on mode. ...
