Toyota RAV4 Service Manual: Tc and cg terminal circuit
Description
Dtc output mode is set by connecting terminals tc and cg of the dlc3.
The dtcs are displayed by blinking the srs warning light.
Hint:
- Make sure that dtc b1281 has not been output. If dtc b1281 has been output, refer to the multiplex communication system.
- When each warning light keeps blinking, a ground short in the wiring of terminal tc of the dlc3 or an internal ground short in each ecu is suspected.
Wiring diagram
Inspection procedure
- Check wire harness (dlc3 - ecm)
- Turn the ignition switch off.
- Disconnect the a9 connectors from the center airbag sensor .
- Measure the resistance of the wire harness side connectors.
Standard resistance 
- Check wire harness (cg of dlc3 - body ground)
- Measure the resistance of the wire harness side connectors.
Standard resistance
- Check wire harness (tc of ecm)
- Measure the resistance of the wire harness side connector.
Standard resistance
- Replace ecm
- Replace the ecm.
- Check the dtc of the ecm (see page es-35).
Result 
Repair or replace wire harness or each ecu
Srs warning light does not come on
Description
The srs warning light is located on the combination meter.
When the srs is normal, the srs warning light comes on for approximately 6
seconds after the ignition
switch is turned fro ...
Other materials:
Short in front passenger side pretensioner squib circuit
Description
The front passenger side front pretensioner squib circuit consists of the
center airbag sensor and the front
seat outer belt rh.
This circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in th ...
Child restraint seat tether anchor
Components
Removal
Remove child restraint seat tether anchor cover
Using a screwdriver, detach the 4 claws and remove
the cover.
Hint:
Tape the screwdriver tip before use.
Remove roof headlining assembly
Hint:
It is not necessa ...
Only rear door lh lock / unlock functions do not operate
Description
The main body ecu receives lock / unlock switch signals and activates the
door lock motor accordingly.
Wiring diagram
Inspection procedure
Inspect rear door with motor lock assembly lh
Apply the battery voltage to the door lock motor and
check the operation of th ...
