Description
Connecting terminals tc and cg of the dlc3 causes the skid control ecu to display 2-digit dtcs by flashing the abs warning light.
Wiring diagram
Inspection procedure
Standard voltage
Result
Replace abs and traction actuator assembly
Standard resistance
Standard resistance
Result
Replace abs and traction actuator assembly
Installation
Caution:
Be sure to read the precautionary notices concerning the
srs airbag system before servicing it (see page rs-1).
Install roof side rail bracket lh
Install the bracket with the 2 bolts.
Torque: 14 n*m (143 kgf*cm, 10 ft.*Lbf)
Install curtain shield airbag assembly lh ...
Connecting a bluetooth®
device
Up to 5 bluetooth® devices (phones (hfp) and audio players
(avp)) can be registered.
If more than 1 bluetooth® device has been registered, select
which device to connect to.
Press the “setup” button.
Select “bluetooth*”.
*: Bluetooth is a registered trademark of bluetooth sig ...
Inspection
Inspect camshaft position sensor
Measure the resistance of the sensor.
Standard resistance
Notice:
Cold and hot mean the temperature of the coils
themselves. Cold is from -10 to 50°c (14 to 122
°f) and hot is from 50 to 100°c (122 to 212°f).
If the result is not as specif ...