Toyota RAV4 Service Manual: Terminals of ecm
- Check ecm
- Measure the voltage of the ecm connector.
Hint:
Each ecm terminal's standard voltage is shown in the table below.
In the table, first follow the information under "condition". Look under "symbols (terminal no.)" For the terminals to be inspected. The standard voltage between the terminals is shown under "specified condition".
Use the illustration above as a reference for the ecm terminals.
- Using an oscilloscope, check the waveform 1.
Waveform 1 (reference) 
- Using an oscilloscope, check the waveform 2.
Waveform 2 (reference) 
- Using an oscilloscope, check the waveform 3.
Waveform 3 (reference) 
- Using an oscilloscope, check the waveform 4.
Waveform 4 (reference) 
- Using an oscilloscope, check the waveform 5.
Waveform 5 (reference) 
- Using an oscilloscope, check the waveform 6.
Waveform 6 (reference) 
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column ...
Diagnosis system
Description
When troubleshooting on-board diagnostic (obd
ii) vehicles, the vehicle must be connected to the
obd ii scan tool (complying with sae j1987).
Various data output from the ...
Other materials:
Dtc check / clear
Check dtc
Hint:
When dtc b1650/23 is detected as a result of
troubleshooting for the airbag system, troubleshoot
the occupant classification system.
Use the intelligent tester (with can vim) to read and
clear dtcs, otherwise the dtcs cannot be read and
cleared.
Connect ...
Before driving
Floor mat
Use only floor mats designed specifically for vehicles of the same
model and model year as your vehicle. Fix them securely in place
onto the carpet.
Insert the retaining hooks (clips)
into the floor mat eyelets.
Turn the upper knob of each
retaining hook (clip) to secure
t ...
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the tire pressure
warning system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
...
