Toyota RAV4 Service Manual: Terminals of ecu
- Check transponder key amplifier
- Disconnect the e5 amplifier connector.
- Measure the resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction in the wire harness.
- Reconnect the e5 amplifier connector.
- Measure the resistance and voltage of the connector.
If the result is not as specified, there may be a malfunction in the amplifier.
- Using an oscilloscope, check the waveform 1.
Waveform 1 (reference): 
- Using an oscilloscope, check the waveform 2.
Waveform 2 (reference): 
- Check transponder key ecu
- Disconnect the e46 ecu connector.
- Measure the resistance and voltage of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the e46 ecu connector.
- Measure the resistance and voltage of the connector.
If the result is not as specified, there may be a malfunction in the ecu.
- Using an oscilloscope, check the waveform 1.
Waveform 1 (reference): 
- Using an oscilloscope, check the waveform 2.
Waveform 2 (reference): 
- Using an oscilloscope, check the waveform 3.
Waveform 3 (reference):
- Using an oscilloscope, check the waveform 4.
Waveform 4 (reference): 
- Check ecm
- Measure the resistance and voltage of the wire harness side connector.
If the result is not as specified, there may be a malfunction in the wire harness.
- Using an oscilloscope, check the waveform 1.
Waveform 1 (reference): 
- Using an oscilloscope, check the waveform 2.
Waveform 2 (reference): 
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column ...
Diagnosis system
Description
Engine immobiliser system data and diagnostic
trouble codes (dtcs) can be read through the
vehicle's data link connector 3 (dlc3). In some
cases, a malfunction may be occurr ...
Other materials:
Disassembly
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove no. 1 Rear seat reclining cover lh
Remove the 2 screws.
Using a screwdriver, detach the 5 claws and remove
the cover.
Hint:
Tape the screwdriver tip before ...
Components
...
Precaution
Handling precaution for cruise control system
Turn the cruise control main switch off when not
using the cruise control system.
Be careful as the vehicle speed increases when
driving downhill with the cruise control system on.
The resume/accel operation changes according
to the cr ...
