Toyota RAV4 manuals

Toyota RAV4 Service Manual: Terminals of ecu

  1. Check combination meter assembly

  1. Disconnect the e19 meter connector.

Toyota RAV4. Check combination meter assembly


  1. Measure the voltage and resistance of the wire harness side connector.

Toyota RAV4. Check combination meter assembly


If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Check heater control panel (for automatic air conditioning system)

  1. Disconnect the e23 panel connector.

Toyota RAV4. Check heater control panel (for automatic air conditioning system)


  1. Measure the voltage and resistance of the wire harness side connector.

Toyota RAV4. Check heater control panel (for automatic air conditioning system)


If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Check clock assembly (for manual air conditioning system)

Toyota RAV4. Check clock assembly (for manual air conditioning system)


  1. Disconnect the e22 clock connector.
  2. Measure the voltage and resistance of the wire harness side connector.

Toyota RAV4. Check clock assembly (for manual air conditioning system)


If the result is not as specified, there may be a malfunction on the wire harness side.

Problem symptoms table
Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected area" column of th ...

Diagnosis system
Description Data of the system can be read through the data link connector 3 (dlc3) of the vehicle. Therefore, when the system seems to be malfunctioning, use the intelligent tester t ...

Other materials:

Installation
Install rear differential support Install the differential support to the differential carrier with the 4 bolts. Torque: 98 n*m (999 kgf*cm, 72 ft.*Lbf) Install rear differential no. 1 And no. 2 Support Install the differential no. 1 And no. 2 Supports with the 4 bo ...

Adjusting the settings manually
To adjust the fan speed, press   on   to increase the fan speed and    to decrease the fan speed. Press  to turn the fan off. To adjust the temperature setting, turn  clockwise to increases the temperature and turn  counterclockwise to ...

Data list / active test
Read data list Hint: Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time. Connect the intelligent tester to the dlc3. Turn the igni ...

В© 2011-2024 Copyright www.trav4.net