Toyota RAV4 Service Manual: Terminals of ecu
- Check tire pressure warning ecu
- Disconnect the e56 ecu connector.
- Measure the voltage and resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the e56 ecu connector.
- Measure the voltage of the connector.
If the result is not as specified, the ecu may have a malfunction.
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column ...
Diagnosis system
Check dlc3
The ecm uses iso 15765-4 for communication. The
terminal arrangement of the dlc3 complies with sae
j1962 and matches the iso 15765-4 format.
If the result is not as spe ...
Other materials:
Short in front passenger side pretensioner squib circuit
Description
The front passenger side front pretensioner squib circuit consists of the
center airbag sensor and the front
seat outer belt rh.
This circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in th ...
Disassembly
Remove no. 3 Heater to register duct
Detach the 6 claws and remove the heater to
register duct.
Remove air duct
Detach the 2 claws and remove the air duct.
Remove air outlet control servo motor
Remove the 3 screws.
Detach the evaporator case from the ...
Circuit inspection
A description of the main areas of each circuit inspection
is below.
Item
Description
description
The major role, operation of the circuit and its component parts are
explained.
Dtc no., Dtc detection condition, trouble area
Indicates the diagnostic trouble cod ...
