Toyota RAV4 Service Manual: Terminals of ecu (2005/11-2006/01)
- Check air conditioning amplifier
- Measure the voltage and resistance of the connectors.
Hint:
Check from the rear of the connector while it is connected to the air conditioning amplifier.
- Using an oscilloscope, check waveform 1.
Compressor and pulley operation signal
- Using an oscilloscope, check waveform 2.
Blower motor control signal 
Hint:
When the blower level is increased, the duty ratio changes accordingly.
- Using an oscilloscope, check waveform 3.
Can communication signal 
Hint:
The waveform varies depending on the can communication signal.
- Using an oscilloscope, check waveform 4.
Can communication signal 
Hint:
The waveform varies depending on the can communication signal.
- Check air conditioning control
- Measure the voltage and resistance of the connectors.
Problem symptoms table (2006/01- )
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column ...
Terminals of ecu (2006/01- )
Check air conditioning amplifier
Measure the voltage and resistance of the
connectors.
Hint:
Check from the rear of the connector while it is
connected to the air conditioning ampl ...
Other materials:
Dinghy towing
Your vehicle is not designed to be dinghy towed (with 4 wheels
on the ground) behind a motor home.
Notice
To avoid serious damage to your vehicle
Do not tow your vehicle with 4 wheels on
the ground.
To prevent causing serious damage to the transmission and dynamic
torque control awd system ( ...
Air inlet control servo motor
Components
Removal
Remove blower assembly
Remove the blower (see page ac-203).
Remove air inlet control servo motor (see
page ac-210)
Inspection
Inspect air inlet control servo motor (for automatic air conditioning
system)
Inspect the servo motor operation. ...
License plate light assembly
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove back door center garnish (see page
ed-59)
...
