Hint:
Check from the rear of the connector while it is connected to the air conditioning amplifier.
Hint:
*: For 2gr-fe
A/c compressor* operation signal
Hint:
*: Compressor and pulley for 2az-fe, compressor and magnetic clutch for 2gr-fe.
Blower motor control signal
Hint:
When the blower level is increased, the duty ratio changes accordingly.
Can communication signal
Hint:
The waveform varies depending on the can communication signal.
Can communication signal
Hint:
The waveform varies depending on the can communication signal.
Compressor lock sensor signal*
Hint:
*: For 2gr-fe
Power supply relay failure
Description
If the power steering ecu detects these dtcs, it shuts off the motor relay
circuit (built into the power
steering ecu) and stops power assist.
Inspection procedure
Reconfirm dtc
Check for dtc.
Ok:
dtc is not output.
Replace power steering ecu ...
Reassembly
Install piston
Using a small screwdriver, install a new snap ring
onto one end of the piston pin hole.
Hint:
Make sure that the end gap of the snap ring is not
aligned with the pin hole cutout portion of the piston.
Gradually heat the piston up to 80 to 90°c (176 to
194°f ...
Rear differential side gear shaft oil seal
Components
Removal
Drain differential oil (see page df-10)
Remove tailpipe assembly
Remove the tailpipe (see page ex-2).
Remove center exhaust assembly
Remove propeller with center bearing
shaft assembly (see page pr-3)
Remove rear differential carrier subassembl ...