Hint:
The dtcs for other inspection items may not be erased when only a certain signal is inspected.
Hint:
After completing the signal check for each inspection item, the dtcs that are determined normal by the tire pressure warning ecu will be erased. The dtcs for other inspection items may not be erased when only a certain signal is inspected.
Hint:
The transmitter id can be transmitted by rapidly reducing the tire pressure.
Hint:
After the signal check is completed, check for a dtc and signal check dtc to confirm the system status.
After completing test mode (signal check), turn the ignition switch off and disconnect the tester.
Dtc of signal check (test diagnosis) function: If a malfunction code is displayed during the test mode dtc check, check the circuit listed for that code. For details of each code, refer to the "see page" of the "dtc no." In the chart.
Components
...
Evaporative emission system switching valve control
Dtc summary
Hint:
The vent valve is built into the canister pump module.
Description
The description can be found in the evap (evaporative emission) system (see
page es-335).
Inspection procedure
Refer to the evap system (see page es-340).
Monitor description
5 Hours* after the ign ...
Installation
Install generator assembly
Confirm that the wire harness of the crankshaft
position sensor is secured to the wire harness
clamp bracket through the back of the rib of the
timing chain cover.
Install the generator with the 2 bolts.
Torque: 21 n*m (215 kgf*cm, 16 ft.*Lb ...