Toyota RAV4 manuals

Toyota RAV4 Owners Manual: Tilting up and down

  1. Tilts the moon roof up*
  2. Tilts the moon roof down*

*: Lightly press either end of the moon roof switch to stop the moon roof partway.

Toyota RAV4. Tilting up and down


The moon roof can be operated when

The engine switch is in the “on” position.

The engine switch is in ignition on mode.

Operating the moon roof after turning the engine off

The moon roof can be operated for approximately 45 seconds after the engine switch is turned to the “acc” or “lock” position. It cannot, however, be operated once either front door is opened.

The moon roof can be operated for approximately 45 seconds after the engine switch is turned to accessory mode or turned off. It cannot, however, be operated once either front door is opened.

If an object is detected between the moon roof and the frame while the moon roof is closing or tilting down, travel is stopped and the moon roof opens.

When the moon roof is opened automatically, it will stop slightly before the fully open position. Driving with the moon roof in this position can help reduce wind noise.

The sunshade can be opened and closed manually. However, the sunshade will open automatically when the moon roof is opened.

Quickly press and release the switch.

Moon roof open reminder function

The buzzer sounds when the engine switch is turned to the “lock” position and the driver’s door is opened with the moon roof open.

The buzzer sounds when the engine switch is turned off and the driver’s door is opened with the moon roof open.

When the battery is disconnected or the moon roof does not close normally

The moon roof must be initialized in order to ensure proper operation.

  1. Turn the engine switch to the “on” position (vehicles without a smart key system) or ignition on mode (vehicles with a smart key system).
  2. Press and hold the “close” or “up” switch until the following movement finishes.

The moon roof will tilt up and pause for 1 second or more.

Then it will tilt down, open and close fully.

  1. Release the switch, and then press it in order to ensure proper operation.

If the moon roof does not move automatically, perform the procedure again from the beginning.

Customization

Settings (e.G. Open reminder function) can be changed.

Caution

Observe the following precautions.

Failure to do so may cause death or serious injury.

Opening the moon roof

Closing the moon roof

Jam protection function

Opening and closing
Opens the moon roof* The moon roof stops slightly before the fully open position to reduce wind noise. Press the switch again to fully open the moon roof. Closes the moon roof* *: L ...

Driving
...

Other materials:

Slip indicator light does not come on
Description Refer to the description of "slip indicator light remains on" (see page bc-152). Wiring diagram Refer to the slip indicator light circuit (see page bc-152). Inspection procedure Notice: When replacing the abs and traction actuator, perform the zero point calibration ( ...

Front shock absorber with coil spring
Components Removal Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove front wheel Disconnect front speed sensor lh Disconnect front stabilizer link assembly lh Remove front shock absorber with coil spring lh ...

Using the “setup” menu (“bluetooth*” menu)
Registering a bluetooth® device in the system allows the system to function. The following functions can be used for registered devices: Functions and operation procedures Press the “setup” button and select “bluetooth*” using the “tune•scroll” knob. Press the knob and sele ...

© 2011-2024 Copyright www.trav4.net