Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Tire and wheel system

Inspection

  1. Inspect tire

  1. Check the tires for wear and proper inflation pressure.

Standard cold tire inflation pressure: 220 kpa (2.2 Kgf/cm2, 32 psi)

  1. Using a dial indicator, check the runout of the tires.

Toyota RAV4. Inspect tire


Standard tire runout: 1.0 Mm (0.039 In.) Or less

  1. Rotate tire

Toyota RAV4. Rotate tire


Hint:

See the illustration for tire rotation.

  1. Inspect wheel balance

  1. Check and adjust the off-the-car balance.

Standard imbalance after adjustment: 8.0 G (0.018 Lb) or less

  1. Check front axle hub bearing (see page ah- 6)

  2. Check bearing backlash and axle hub deviation (see page ah-16)

Tire and wheel
...

Tire pressure warning system
...

Other materials:

On-vehicle inspection
Inspect refrigerant pressure with manifold gauge set This method uses a manifold gauge set to locate problem areas. Read the manifold gauge pressure when these conditions are established. Test conditions: Temperature at the air inlet is 30 to 35°c (86 to 95°f). Engine is ...

Rear occupant classification sensor lh collision detection
Description Dtc b1787 is output when the occupant classification ecu receives a collision detection signal sent by the rear occupant classification sensor lh when an accident occurs. Dtc b1787 is also output when the front seat assembly rh is subjected to a strong impact, even if an actua ...

Air conditioning amplifier communication stop mode
Description Wiring diagram Inspection procedure Notice: Turn the ignition switch off before measuring the resistances of the main wire and the branch wire. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning sy ...

© 2011-2026 Copyright www.trav4.net