Toyota RAV4 Service Manual: Tire pressure warning ecu
Components
Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove glove compartment door assembly (see page ip-20)
- Remove tire pressure warning ecu
- Disconnect the connector.
- Remove the bolt and ecu.
Installation
- Install tire pressure warning ecu
- Install the ecu with the bolt.
Torque: 4.5 N*m (46 kgf*cm, 40 in.*Lbf)
- Connect the connector.
- Install glove compartment door assembly (see page ip-25)
- Connect cable to negative battery terminal
- Register transmitter id (see page tw-10)
- Inspect tire pressure warning system
Tire pressure warning valve and transmitter
Components
Removal
Remove front tire
Remove rear tire
Remove tire pressure warning valve subassembly
Remove the valve core and cap, and release air
from the tire.
After ensuring ...
Air conditioning
...
Other materials:
Solar sensor circuit (passenger side)
Description
The solar sensor, which is installed on the upper side of the instrument
panel, detects sunlight and
controls the air conditioning auto mode. The output voltage from the solar
sensor varies in accordance
with the amount of sunlight. When the sunlight increases, the output volt ...
Assist grips
An assist grip installed on the ceiling
can be used to support your
body while sitting on the seat.
Caution
Assist grip
Do not use the assist grip when getting in or out of the vehicle or
rising from
your seat.
Doing so could damage the assist grip, or could cause you to injure yourse ...
Security indicator light circuit
Description
When the transponder key is registered, the transponder key ecu indicates the
key registration condition
by lighting up, blinking or turning off the security indicator.
Wiring diagram
Inspection procedure
Perform active test by intelligent tester (security indicator light)
...
