Toyota RAV4 Service Manual: Torque converter clutch solenoid circuit
Description
The shift solenoid valve dsl is turned on and off by signals from the ecm to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch.
Fail-safe function: if the ecm detects a malfunction, it turns the shift solenoid valve dsl off.
Monitor description
Torque converter lock-up is controlled by the ecm based on engine rpm, engine load, engine temperature, vehicle speed, transmission temperature, and shift position selection. The ecm determines the lock-up status of the torque converter by comparing the engine rpm (ne) to the input rpm (nt). The ecm calculates the actual transmission gear by comparing the input rpm (nt) to the output rpm (sp2).
When conditions are appropriate, the ecm requests "lock-up" by applying control voltage to the shift solenoid valve dsl. When the shift solenoid valve dsl is opened, the shift solenoid valve dsl applies pressure to the lock-up relay valve and locks the torque converter clutch. If the ecm detects an open or short in the shift solenoid valve dsl circuit, the ecm interprets this as a fault in the shift solenoid valve dsl or its circuit. The ecm will illuminate the mil and store a dtc.
Monitor strategy
Typical enabling conditions
Typical malfunction thresholds
Component operating range
Wiring diagram
Refer to dtc p0741 (see page ax-62).
Inspection procedure
- Inspect transmission wire (shift solenoid valve dsl)
- Disconnect the b27 wire connector.
- Measure the resistance of the transmission wire.
Standard resistance 
- Check wire harness (transmission wire - ecm)
- Disconnect the b30 ecm connector.
- Measure the resistance of the wire harness side connector.
Standard resistance 
Replace ecm
- Inspect shift solenoid valve dsl
- Remove the shift solenoid valve dsl.
- Measure the resistance between the solenoid valve terminal and solenoid valve body.
Standard resistance:
11 to 13 
at 20°c (68°f)
- Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating noise.
Ok: valve moves and makes operating noise.
Repair or replace transmission wire
Pressure control solenoid "d" electrical (shift solenoid valve slt)
Description
Refer to dtc p2714 (see page ax-91).
Monitor description
When an open or short in the shift solenoid valve slt circuit is detected,
the ecm interprets this as a fault.
The ...
Automatic transaxle fluid
On-vehicle inspection
Check transaxle fluid level
Hint:
Drive the vehicle so that the engine and transaxle are at
normal operating temperature.
Fluid temperature:
70 to 80°c (158 to 176°f ...
Other materials:
Installation (2005/11-2006/01)
Install sliding roof weatherstrip
Install the sliding roof weatherstrip.
Position the joint of the weatherstrip at the rear
center.
Align the marks on the weatherstrip with the
middle marks at the corners of the plastic on
the edge of the sliding roof panel and install the ...
Lost communication with front satellite sensor bus rh
Description
The front airbag sensor rh consists of the diagnostic circuit and the frontal
deceleration sensor.
If the center airbag sensor receives signals from the frontal deceleration
sensor, it determines whether or
not the srs should be activated.
Dtc b1602/83, b1603/83, b1612/83 ...
Rear no. 2 Suspension arm
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove rear wheel
Disconnect no. 2 Parking brake cable
assembly (see page pb-8)
Disconnect skid control sensor wire (for
2wd) (see page bc-198)
D ...
