Toyota RAV4 (XA40) 2013-2018 Service Manual: Torque sensor
Description
The torque sensor converts the rotation torque input from the steering wheel into electric signals and sends them to the power steering ecu.
Wiring diagram
Inspection procedure
- Check connector connection condition (torque sensor - ecu)
- Check the installation condition of the torque sensor connector.
Ok: torque sensor connector is securely installed to the power steering ecu.
Result 
- Reconfirm dtc
- Reinstall the torque sensor connector.
- Check for dtcs.
Ok:
dtc is not output. 
- Inspect torque sensor
- Turn the ignition switch on.
- Measure the voltage of the ecu.
Standard voltage
Proceed to next circuit inspection shown in problem symptoms table
Diagnostic trouble code chart
Hint:
If any dtcs are displayed during the dtc check, inspect the
circuit listed for these dtcs. For details of each dtc, refer to
the page indicated in the dtc chart.
Hint:
: Warning
...
Short in motor circuit
Description
The power steering ecu supplies current to the power steering motor through
this circuit.
Inspection procedure
Reconfirm dtc
Check for dtc.
Ok:
dtc is not output.
...
Other materials:
Removal and installation of engine intake parts
If any metal particles enter inlet system parts, they
may damage the engine.
When removing and installing inlet system parts,
cover the openings of the removed parts and engine
openings. Use gummed tape or other suitable
materials.
When installing inlet system parts, check that no ...
Short in driver side squib 2nd step circuit
Description
The driver side squib 2nd step circuit consists of the center airbag sensor,
the spiral cable and the
steering pad.
The circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in the driver side squi ...
Automatic transaxle fluid
On-vehicle inspection
Check transaxle fluid level
Hint:
Drive the vehicle so that the engine and transaxle are at
normal operating temperature.
Fluid temperature:
70 to 80°c (158 to 176°f)
Park the vehicle on a level surface and set the
parking brake.
With the engine idling and ...
