Toyota RAV4 Service Manual: Traction control switch (for 2wd)
Components
Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove traction control switch (auto lsd switch)
- Detach the 2 claws and remove the switch.
Inspection
- Check traction control switch (auto lsd switch)
- Measure the resistance of the switch.
Standard resistance 
If the result is not as specified, replace the switch.
- Check illumination operation.
- Connect the battery's positive (+) lead to
terminal 5 and negative (-) lead to terminal 4.
Then check that the bulb illuminates.
Ok: bulb illuminates.
If the result is not as specified, replace the switch.
Installation
- Install traction control switch (auto lsd switch)
- Attach the 2 claws to install the switch.
- Connect cable to negative battery terminal
Downhill assist control switch
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Other materials:
Installation (2006/01- )
Install front drive shaft assembly lh
Coat the spline of the inboard joint shaft with gear
oil.
Align the shaft splines and tap in the drive shaft with
a brass bar and hammer.
Notice:
Set the snap ring with the opening side facing
downwards.
Be careful not to damage the ...
How to proceed with troubleshooting
Notice:
Dtcs for the can communication system are as
follows: u0073, u0100, u0105, u0121, u0122, u0123,
u0124, u0126, u0129, c1280, c1296, c1297, and
b1499.
Refer to the troubleshooting procedures of each
system if dtcs regarding the can communication
system are not output.
Turn th ...
Freeze frame data
Description
Freeze frame data records the engine conditions (fuel
system, calculated load, engine coolant temperature,
fuel trim, engine speed, vehicle speed, etc.) When a
malfunction is detected. When troubleshooting, it can
help determine if the vehicle was running or stopped, the
engin ...
