Description
The park/neutral position (pnp) switch detects the shift lever position and sends signals to the ecm.
Monitor description
These dtcs indicate a problem with the park/neutral position switch and the wire harness in the park/ neutral position switch circuit.
The park/neutral position switch detects the shift lever position and sends a signal to the ecm.
For security, the park/neutral position switch detects the shift lever position so that the engine can be started only when the shift lever is on p or n.
The park/neutral position switch sends a signal to the ecm according to the shift lever position (r, d, 3, 2 or l).
The ecm determines that there is a problem with the switch or related parts if it receives more than 1 position signal simultaneously. The ecm will illuminate the mil and store the dtc.
Monitor strategy
Typical enabling conditions
Typical malfunction thresholds
Component operating range
Wiring diagram
Inspection procedure
Hint:
Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time.
Notice:
In the table below, the values listed under "normal condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Standard voltage
Standard resistance
Standard voltage
Hint:
*: The voltage will drop slightly due to the illumination of the back-up light.
Standard voltage
Standard resistance
Standard voltage
Hint:
*: The voltage will drop slightly due to the illumination of the back-up light.
Terminals of ecu
Check tire pressure warning ecu
Disconnect the e56 ecu connector.
Measure the voltage and resistance of the wire
harness side connector.
If the result is not as specified, there may be a
malfunction on the wire harness side.
Reconnect the e56 ecu connector.
Measure the ...
Short in front driver side - side squib circuit
Description
The driver side - side squib circuit consists of the center airbag sensor and
the front seat side airbag lh.
This circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in the driver side - side
sq ...
Operation check
Check electrical door lock operation
Check the basic function.
Check that all doors lock when the door control
switch (for manual operation) is turned to lock
and all doors unlock when turned to unlock.
Check that all doors lock when the driver side
door lock key cylinder is t ...