Description
Inspection procedure
Notice:
It is necessary to register an id code after replacing the tire pressure warning valve and transmitter and/or the tire pressure monitor ecu (see page tw-9).
Hint:
Set the tire pressure to the specified value.
Standard pressure: 220 kpa (2.2 Kgf/cm2, 32 psi)
Tire pressure warning ecu
Ok: the registered transmitter id codes are displayed on the intelligent tester screen.
Standard pressure: 220 kpa (2.2 Kgf/cm2, 32 psi)
Ok: all tire pressure readings are equal to the actual tire pressure.
Notice:
It may take up to 1 minute to display the tire pressure data.
End
Air fuel ratio sensor
Components
On-vehicle inspection
Check air fuel ratio compensation system
Connect the intelligent tester to the dlc3.
Turn the ignition switch on.
Select the following menu items: data list / a/fs b1
s1 and o2s b1 s2.
Warm up the a/f sensor with the engine speed at
2,500 ...
Skid control sensor (for 2wd)
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
Front console illumination
On-vehicle inspection
Inspect front console illumination
Connect the battery's positive (+) lead to terminal 1
and the negative (-) lead to terminal 2, then check
that the light comes on.
Ok:
light comes on.
If the result is not as specified, replace the front
console illumin ...