Inspection
Standard resistance
If the result is not as specified, replace the switch assembly.
Ecu power source circuit
Description
This circuit provides power to operate the transponder key ecu.
Wiring diagram
Inspection procedure
Standard resistance: below 1
Standard resistance
Standard voltage
Proceed to next circuit inspection shown in problem symptoms table
General maintenance (2006/01- )
Inspect steering linkage and gear housing
Check the steering wheel free play.
Check the steering linkage for looseness or
damage.
Check that the tie rod ends do not have
excessive play.
Check that the dust seals and boots are not
damaged.
Check that the boot clamps are not ...
Installation
Install starter assembly
Install the starter with the 2 bolts.
Torque: 37 n*m (377 kgf*cm, 27 ft.*Lbf)
Connect the starter connector.
Install the terminal nut and cover the nut with the
cap.
Torque: 9.8 N*m (100 kgf*cm, 7 ft.*Lbf)
Install battery bracket reinfor ...
Reassembly (2006/01- )
Install drive shaft bearing case subassembly
(for rh)
Install the bearing snap ring.
Using sst and a press, press in the drive shaft
bearing case to the inboard joint rh.
Sst 09527-10011, 09710-04081
Notice:
The bearing should be installed completely.
Using a snap rin ...