Toyota RAV4 (XA40) 2013-2018 Service Manual: Unmatched key code
Description
This dtc is output when a key code that has not been registered in the transponder key ecu is inserted into the ignition key cylinder.
Inspection procedure
- Reregister key
- Clear the dtc (see page ei-18).
- Reregister the key code with the transponder key ecu (see page ei-5)
- Check that the engine starts with the key.
Ok: engine starts.
End
Unmatched encryption code
Description
This dtc is output when a key with an incomplete key code is inserted into
the ignition key cylinder.
Inspection procedure
Reregister key
Clear the dtc (see page ei-1 ...
Communication
Description
When a key is inserted into the ignition key cylinder but no communication
occurs between the key and
transponder key ecu, dtc b2796 is output. When a key is inserted into the
ig ...
Other materials:
Oil pump
Components
Removal
Remove chain sub-assembly
Remove the chain (see page em-22).
Remove oil pump assembly
Remove the 3 bolts, oil pump and gasket.
Disassembly
Remove oil pump strainer
Remove the 2 nuts, oil pump strainer and gasket.
...
Winter driving tips
Carry out the necessary
preparations and inspections
before driving the
vehicle in winter. Always
drive the vehicle in a manner
appropriate to the prevailing
weather conditions.
Pre-winter preparations
Use fluids that are appropriate
to the prevailing outside temperatures.
Engine oil
Engine c ...
Wiper switch
Precaution
Precaution for vehicle with srs
Some procedures in this section may affect the
supplemental restraint system (srs). Prior to
performing the procedures, read the srs section's
"precaution" (see page ss-2).
Components
Removal
Disconnect cable from negat ...
