Connect an ipod, usb memory device or portable audio player to the usb/aux port as indicated below. Select “ipod�, “usb� or “aux� on the audio source selection screen and the device can be operated via audio system.
Connecting using the usb/aux port
Ipod
Open the cover and connect an ipod using an ipod cable.
Turn on the power of the ipod if it is not turned on.

Open the cover and connect the usb memory device.
Turn on the power of the usb memory device if it is not turned on.
Open the cover and connect the portable audio player.
Turn on the power of the portable audio player if it is not turned on.
Caution
While driving
Do not connect a device or operate the device controls.
Steering wheel audio switches
Basic audio operationsSkid control sensor (for 2wd)
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
Installation
Caution:
Be sure to read the precautionary notices concerning the
srs airbag system before servicing it (see page rs-1).
Install steering pad assembly
Support the steering pad with one hand as shown in
the illustration.
Connect the 2 airbag connectors.
Notice:
When handling t ...
Removal (2005/11-2006/01)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove roof headlining assembly
Remove the roof headlining (see page ir ...