Description
The tire pressure warning ecu receives a speed signal from the combination meter. This dtc is stored upon entering test mode, and cleared when a vehicle speed signal of 12 mph (20 km/h) is detected for 3 seconds or more. The dtc is output only in test mode.
Wiring diagram
Inspection procedure
Notice:
It is necessary to register an id code after replacing the tire pressure warning valve and transmitter and/or the tire pressure warning ecu (see page tw-9).
Ok: indicates actual speed.
Standard resistance
Standard voltage
Hint:
As the vehicle speed (wheel revolution speed) increases, a cycle of the waveform narrows.
Replace tire pressure warning ecu
Compressor and pulley (for 2gr-fe)
Components
Removal
Discharge refrigerant from
refrigeration system (see page ac-172)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensione ...
Installation
Install upper instrument panel
Attach the 6 clips and 5 claws to install the
instrument panel.
Connect the connectors and clamps.
Install the 2 bolts and 2 screws.
Connect the passenger airbag connector.
Install the 2 bolts to the passenger airbag.
Torque: 20 n*m (204 k ...
Components
(2006/01- )
...