Toyota RAV4 (XA40) 2013-2018 Service Manual: Vehicle stability control system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Check for intermittent problems
- Calibration
- Test mode procedure
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Dtc check / clear
- Freeze frame data
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
- Solenoid circuit
- Open in abs solenoid relay circuit
- Engine control system malfunction
- Ecm communication circuit malfunction
- Abs control system malfunction
- Steering angle sensor circuit malfunction
- Stuck in deceleration sensor
- Low battery positive voltage
- Master cylinder pressure sensor malfunction
- Open in stop light switch circuit
- Open in pump motor circuit
- Brake pedal load sensing switch
- Steering angle sensor zero point malfunction
- Different diameter tire malfunction
- Downhill assist control operation switch (test mode dtc)
- Control module communication bus off
- Abs warning light remains on
- Abs warning light does not come on
- Vsc warning light remains on
- Vsc warning light does not come on
- Brake warning light remains on
- Brake warning light does not come on
- Slip indicator light remains on
- Slip indicator light does not come on
- Downhill assist control indicator light remains on
- Downhill assist control indicator light does not come on
- Auto lsd indicator light remains on
- Auto lsd indicator light does not come on
- Skid control buzzer circuit
- Tc and cg terminal circuit
- Ts and cg terminal circuit
Brake control
...
Precaution
Troubleshooting precaution
When there are malfunctions in the contact points of
the terminals or installation problems with any parts,
removal and installation of the suspected problem
...
Other materials:
Installation
Install front bumper side retainer lh
Install the clip and bumper side retainer.
Install the bolt.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf)
Install front bumper side retainer rh
Hint:
Use the same procedures described for the lh side.
Install front bumper reinforcemen ...
Brake
General maintenance
Inspect brake lines and hoses
Hint:
Work in a well-lighted area. Turn the front wheels fully to
the right or left before beginning the inspection.
Using a mirror, check the entire circumference and
length of the brake lines and hoses for:
Damage
Wear
...
Clock
The clock can be adjusted by pressing the buttons.
Adjusts the hours.
Adjusts the minutes.
The clock is displayed when
Vehicles without a smart key system
The engine switch is in the “acc” or “on” position.
Vehicles with a smart key system
The engine switch is in a ...
