Toyota RAV4 Service Manual: Ventilation valve
Components
Removal
- Remove no. 1 Engine cover (see page em-22)
- Remove ventilation valve sub-assembly
- Disconnect the ventilation hose from the ventilation valve.
- Using a 22 mm deep socket wrench, remove the ventilation valve.
Inspection
- Inspect ventilation valve sub-assembly
- Install a clean hose to the ventilation valve.
- Check the ventilation valve operation.
- Blow air into the cylinder head side, and check that air passes through easily.
Caution:
Do not suck air through the valve.
Petroleum substances inside the valve are hazardous to your health.
- Blow air into the intake manifold side, and
check that air passes through with difficulty.
If the result is not as specified, replace the ventilation valve sub-assembly.
- Remove the clean hose from the ventilation valve.
Installation
- Install ventilation valve sub-assembly
- Apply adhesive to 2 or 3 threads of the ventilation valve.
Adhesive: toyota genuine adhesive 1324, three bond 1324 or equivalent
- Using a 22 mm deep socket wrench, install the ventilation valve.
Torque: 19 n*m (194 kgf*cm, 14 ft.*Lbf)
- Connect the ventilation hose.
- Install no. 1 Engine cover (see page em-43)
- Check for engine oil leaks
Vacuum switching valve
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Air fuel ratio sensor
Components
On-vehicle inspection
Check air fuel ratio compensation system
Connect the intelligent tester to the dlc3.
Turn the ignition switch on.
Select the following menu item ...
Other materials:
Using the aux port
This port can be used to connect a portable audio device and listen
to it using the vehicle’s speakers.
Open the cover and connect
the portable audio device.
Press the “media” button repeatedly until “aux” is displayed.
Silencing a sound
Press
(mute).
To cancel, p ...
Installation (2005/11-2006/01)
Install abs and traction actuator assembly with bracket
Notice:
Do not remove the hole plug before connecting the
brake tube. New actuators are filled with brake fluid.
Install the actuator with bracket with the 3 nuts.
Torque: 19 n*m (194 kgf*cm, 14 ft.*Lbf)
Hint:
The nuts shou ...
Electronic control
Removal and installation of battery
terminal
Notice:
Certain systems need to be initialized after
disconnecting and reconnecting the cable from
the negative (-) battery terminal.
Before performing electronic work, disconnect
the cable from the negative (-) battery terminal to
...
