Toyota RAV4 Service Manual: Vin not programmed or mismatch - ecm / pcm
Description
Dtc p0630 is set when the vehicle identification number (vin) is not stored in the engine control module (ecm) or the input vin is incorrect. Input the vin with the intelligent tester.
Monitor strategy
Typical enabling conditions
Typical malfunction thresholds
Component operating range
Inspection procedure
-
Read current dtc
- Connect the intelligent tester to the dlc3.
- Turn the ignition switch on and turn the tester on.
- Select the following menu items: diagnosis / enhanced obd ii / dtc info / current codes.
- Read dtcs.
If any dtcs other than p0630 are output, troubleshoot those dtcs first.
Notice:
If p0630 is set, the vin must be input to the ecm using the intelligent tester. However, all dtcs are cleared automatically by the tester when the vin is input. If dtcs other than p0630 are set, check them first.
- Input vin with intelligent tester
- Refer to the registration (see page es-14).
Starter relay circuit high
Description
While the engine is being cranked, the positive battery voltage is applied to
terminal sta of the ecm. If
the ecm detects the starter control (sta) signal while the vehicle is bein ...
Brake switch "b" circuit high
Description
The purpose of this circuit is to prevent the engine from stalling while
driving in the lock-up condition when
the brakes are suddenly applied.
When the brake pedal is depressed ...
Other materials:
Tc and cg terminal circuit
Description
Dtc output mode is set by connecting terminals 13 (tc) and 4 (cg) of the
dlc3. The dtcs are indicated
by the blinking of the tire pressure warning light.
Wiring diagram
Hint:
When each warning light continues blinking, a ground short in the wiring of
terminal tc of the dlc3 ...
Blower resistor
On-vehicle inspection
Inspect blower motor control
Measure the resistance of the blower resistor.
Standard resistance
If the resistance is not as specified, replace the
blower motor control. ...
Terminals of ecu
Check instrument panel junction block (main body ecu)
Measure the voltage of the connectors.
If the result is not as specified, the junction block
(main body ecu) may have a malfunction. ...
