Toyota RAV4 Service Manual: Vsc warning light does not come on
Description
Refer to the description of "vsc warning light remains on" (see page bc-139).
Wiring diagram
Refer to the vsc warning light circuit (see page bc-140).
Inspection procedure
Notice:
When replacing the abs and traction actuator, perform the zero point calibration (see page bc- 24).
- Inspect can communication system
- Check if the can communication system dtc is output (see page bc-47).
Result 
- Perform active test by intelligent tester (vsc warning light)
- Select the active test, generate a control command, and then check that the vsc warning light operates.
Ok: the vsc warning light turns on or off.
- Check combination meter assembly
- Check the combination meter (see page ca-34).
Replace abs and traction actuator assembly
Vsc warning light remains on
Description
The skid control ecu is connected to the combination meter via the can
communication system.
W/o multi information display:
if the skid control ecu stores any dtcs which relate to t ...
Brake warning light remains on
Description
If any of the following conditions are detected, the brake warning light
remains on:
The ecu connectors are disconnected from the skid control ecu.
The brake fluid level is insuff ...
Other materials:
Operating a usb memory
Connecting a usb memory enables you to enjoy music from the
vehicle speakers.
Connecting a usb memory
Open the cover and connect
a usb memory.
Turn on the power of the usb
memory if it is not turned on.
Press the “media” button repeatedly until “usb” is displayed.
Cont ...
Fuel injector
Components
Removal
Discharge fuel system pressure
Caution:
Discharge fuel system pressure
procedures must be performed before
disconnecting any part of the fuel system.
After performing the discharge fuel system
pressure procedures, pressure will remain in
the fuel line ...
Windshield wiper de-icer
This feature is used to prevent ice from building up on the windshield
and wiper blades.
On/off
The windshield wiper de-icer will
automatically turn off after approximately
15 minutes. Pressing the
switch again also turns the de-icer
off.
Operating conditions
Vehicles without a smart ...
